JENCO In-line pH Meters pH, ORP In-line Controller 3671N

Jumlah Pesanan:

Negara Asal:

Amerika Serikat

Cara Pembayaran:

Transfer Bank (T/T)

Kemas & Pengiriman:

1 unit

Description
1/ 8 DIN panel mount pH/ ORP controller with dual SPDT Hi/ Lo relays, manual set points and calibration are via potentiometers. Features a voltage/ recorder output and an internal pH/ ORP select switch. Display is a large bright red LED. Connectors are a BNC input and spade lug screw type connector block. Meter requires a Pt-100 ATC or a simulation resistor for temperature. Power115/ 230A AC.

* All solid state design
* Low cost
* Easy to install
* Set points on front panel
* Recorder output
* 0.56 high efficiency red led display
* 1/ 8 DIN aluminum case
* Set points cover entire span
* ATC for pH 0 to 100 ° C
* Internal pH/ ORP select switch
* Low power consumption design, reduced internal heating thus increased reliability

Specifications :
pH
Range : 0 to 14.0
Resolution : 0.1
Accuracy : 0.1 ± 1digit
ORP
Range : -1990 to 1990 mV Resolution : 10
Accuracy : ± 0.1% ± 1 digit
Temp.
Range : 0 to 100 ° C
Resolution : 1
Accuracy : 1 ± 1 digit

#
General

* Input impedance: Greater than 10^ 12 ohm
* Temp. compensation: Auto 0 to 100 ° C
* Recorder output ( ph) : 1400mV
* Recorder output ( mV) : -1990 to 1990mV
* Recorder output ( temp.) : 1000mV
* Dual point on/ off control: pH or orp with internal select switch
* Dead band: ± 0.1 pH for each set point
* Relay output: 8a at 115VAC, 4a at 230VAC
* Readout: 0.56 high efficiency red LED display
* Power source: 115 VAC/ 230VAC ¡ à 15% , 50/ 60hz
* Dimension: 96mm x48mm x 172mm
* Weight: 0.69 kg

Kenalkan ke teman Anda