Clemco 0.5 and 1 Cuft Classic Blast Machines

Jumlah Pesanan:

High-performance, versatile blast cleaning system removes contamination, corrosion, mill scale, and coatings from most surfaces. Produces a uniform surface texture, and creates a surface profile to increase bonding for coatings.

Model 1028 holds 1/ 2 cubic foot of abrasive providing approximately 15 minutes of blasting at 80 psi with a No. 3 ( 3/ 16-inch) nozzle.

Model 1042 holds 1 cubic foot of abrasive providing approximately 15 minutes of blasting at 80 psi with a No. 4 ( 1/ 4-inch) nozzle.

Requirements for Operation
These items are required but not included with this equipment:

Clean, dry, compressed air of sufficient volume to maintain desired pressure at the nozzle. Refer to Air Consumption Chart in Blast Off 2 booklet ( publication stock no. 09294) .
Minimum 12 cfm at 50 psi needed to close the pop-up valve and pressurize the blast machine.
OSHA-required remote control system that interrupts blasting if operator should lose control of the nozzle when blast machine is pressurized.
NIOSH-approved, type CE, supplied-air respirator.
Grade D breathing-air supply as defined by Compressed Gas Association Commodity Specification: G-7.1 ( Refer to www.cganet.com) .
Abrasive blast media specifically marketed for abrasive blasting and appropriate for your application.
Appropriate blast suit, work boots, hearing and eye protection.

Description of Operation
The operator controls blasting from a remote control handle at the nozzle. Pressing the handle starts blasting; releasing it stops blasting. The blast machine contains abrasive and meters it into the compressed air stream.

Kenalkan ke teman Anda