FILTER HOLDER GLASS
Made in Advantech - Japan

Microanalysis filter holders can be used with a filtering flask or a vacuum manifold to collect samples for particulate or microbiological analysis.

Glass Units:

Glass Frit Support ( 13, 25, 47, 90 mm)
Stainless Steel Support ( 25, 47, 90 mm)
Teflon Support ( 47 mm)
Teflon Coated Seal ( Stainless or Teflon Support) ( 47 mm)

vacuum filter holder

Polysulfone Units ( 47 mm) :

* Rugged autoclavable units can be purchased with a receiver flask or used with manifold or vacuum flask
* 300 ml or 500 ml funnel.

Stainless Steel Unit ( 47 mm) :

* Type 304 stainless steel can be flame sterilized, capacity 700 ml
* Set pins and locking nut for easy assembly without tearing membrane.

wpe7.gif ( 1125 bytes)

All-Glass Filtration Assemblies ( 25, 47 mm) :

* Samples filtered and collected directly into a glass receiving flask, all wetted surfaces are borosilicate glass
* Filter holder connects directly to flask with ground glass joint

wpe11.gif ( 1360 bytes)

Phase/ Fraction Collectors ( 47 mm) :

* Collect aliquots or direct filtrate to manifold or flask using 2-way Teflon valve
* Suitable for EPA method 1664: Oil and Grease and Total Petroleum Hydrocarbons.

Contact Advantec MFS
for more information on these products

Sterility Test Apparatus ( 47 mm) :

*
Used in sterility testing of antibiotics, bacteriostatic, and fungistatic drugs by the USP bacteria retentive method

Contact Advantec MFS
for more information on these products

Compatible equipment:
Stainless Steel Vacuum Manifolds
PVC Vacuum Manifolds
Membranes
Petri Dishes and Microbiological Media